Hak5 2003 – Soldering the Flight Controller – Drone Building 101

We continue our drone build by soldering the flight controller and finalizing the motor wiring!
——————————-
Shop: http://www.hakshop.com
Support: http://www.patreon.com/threatwire
Subscribe: http://www.youtube.com/hak5
Our Site: http://www.hak5.wpengine.com
Contact Us: http://www.twitter.com/hak5
——————————
Check out Episode 20×01 and 20×02 for the first two parts of this series.

Carbon Fiber 210 mm H frame (QAV210 or similar)
http://amzn.to/21hoCB8
http://amzn.to/1X7m5Zg

Power Distribution Board with 5 Volt and 12 Volt regulators
http://amzn.to/1X7m7QJ

M2 Nylon Standoffs and Screws
http://amzn.to/1QC96hM

NAZE32 Flight Controller
http://amzn.to/1X7meMi

4x 20 Amp Electronic Speed Controllers with BLHeli firmware
http://amzn.to/1TEXOMm

4x Brushless Motors, either 1804 2300-2400KV or 1306 3100KV
http://amzn.to/1QC9bC4
http://amzn.to/1TEXUDy

4x Carbon Fiber 5030 Propeller either 3-hole or 1-hole depending on motor mount (2 clockwise, 2 counter-clockwise)
http://amzn.to/1QC9eOh
http://amzn.to/1QC9hcM

1x Spektrum compatible DSM2 or DSMX Satellite Receiver
http://amzn.to/1QC9iNR
http://amzn.to/1TEY1PJ

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>